PUMPS AND VENTILATION - VENTILATION - BILGE BLOWERS
(Select from these Groups)
Click pictures to see enlarged view!
TURBO 3000 BLOWERS By ATTWOOD CORP
Patented in-line design – provides ventilation for engine compartments, galleys, bilges, and heads. Mounting feet allow vertical or horizontal installation in confined spaces. Install with #10 fasteners. Individual carton includes 2 tie straps. All are CE certified. 16-gauge tinned and caulked copper wire leads with optional MP1 molded rubber connectors. Improved 3" design includes: •Nickel-plated motor can for corrosion resistance •Stiffening ribs to reduce housing distortion •Motor cap to seal wires and motor for water resistance
TURBO 4000 SERIES II BLOWERS By ATTWOOD CORP
Attwood's new and improved Turbo 4000 Series II sets the standard for in-line blower performance. Utilizing advanced fan blade design techniques, Attwood has developed a blower system that matches air flow of existing in-line blowers at a significantly reduced noise level. For added durability, Attwood incorporates an engineered plastic housing that resists deformation during installation and prevents blade to housing interference.
TUNNEL BLOWERS By DETMAR CORP
The tunnel design places the motor in the center of the air flow for cooler operation, which results in lower amperage draw. All models are BIA approved and rated and meet U.S.C.G. Safety Standards. Blower housing of ABS plastic. Special clips on all hose flanges eliminate the need for hose clamps.
FLANGE MOUNT BLOWERS By THE RULE GROUP
Quiet running, low amp draw 12 and 24 Volt DC model blowers. 7.1m3/min (250cfm) output.
FLANGE MOUNT VENTILATOR By THE RULE GROUP
Flange mount model attaches to the wall directly with screws on the blower body flange. 105 CFM capacity. Voltage 12 volts, DC. Current consumption 4.25 amps.
FLEX MOUNT VENTILATOR By THE RULE GROUP
By attaching flexible ducting to either inlet or outlet collars, the flex mount model ventilates remote enclosed areas. Bracket may be rotated to permit mounting the ventilator with the outlet facing any direction. Flexible ducting will fit onto both inlet and outlet collar without adapters. 105 CFM capacity. Voltage 12 volts, DC. Current consumption 4.25 amps.
RULE® IN-LINE BLOWER By THE RULE GROUP
Rule® in-line blowers provide ventilation for bilges, engine compartments, galleys and heads. Designed for efficient, high output operation, these blowers feature our exclusive front and rear shaft seals and corrosion resistant motor housings for long life. Compact and easily installed on any flat surface, Rule® in-line blowers provide higher air flow, lower amp draw and quieter operation than standard blowers.